When a document is recorded in non-complex format, the bounds of the paragraph that contains a particular character can be found by calculating the FC coordinate of the character, searching the bin table to find an FKP page that describes that FC, fetching that FKP, and then searching the FKP to find the interval in the rgfc that encloses the character. The bounds of the interval are the fcFirst and fcLim of the containing paragraph. Every character greater than or equal to fcFirst and less than fcLim is part of the containing paragraph.
When a document is recorded in complex format, a piece that was originally part of one paragraph can be copied or moved within a different paragraph. To find the beginning of the paragraph containing a character in a complex document, it's first necessary to search for the piece containing the character in the piece table. Then calculate the FC in the file that stores the character from the piece table information. Using the FC, search the FCs FKP for the largest FC less than the character's FC, call it fcTest. If the character at fcTest-1 is contained in the current piece, then the character corresponding to that FC in the piece is the first character of the paragraph. If that FC is before or marks the beginning of the piece, scan a piece at a time towards the beginning of the piece table until a piece is found that contains a paragraph mark. This can be done by using the end of the piece FC, finding the largest FC in its FKP that is less than or equal to the end of piece FC, and checking to see if the character in front of the FKP FC (which must mark a paragraph end) is within the piece. When such an FKP FC is found, the FC marks the first byte of paragraph text.
To find the end of a paragraph for a character in a complex format file, again it is necessary to know the piece that contains the character and the FC assigned to the character. Using the FC of the character, first search the FKP that describes the character to find the smallest FC in the rgfc that is larger than the character FC. If the FC found in the FKP is less than or equal to the limit FC of the piece, the end of the paragraph that contains the character is at the FKP FC minus 1. If the FKP FC that was found was greater than the FC of the end of the piece, scan piece by piece toward the end of the document until a piece is found that contains a paragraph end mark. It's possible to check if a piece contains a paragraph mark by using the FC of the beginning of the piece to search in the FKPs for the smallest FC in the FKP rgfc that is greater than the FC of the beginning of the piece. If the FC found is less than or equal to the limit FC of the piece, then the character that ends the paragraph is the character immediately before the FKP FC.
A special procedure must be followed to locate the last paragraph of the main document text when footnote or header/footer text is saved in a Word file (i.e. when fib.ccpFtn != 0 or fib.ccpHdr != 0).
In this case the CP of that paragraph mark is fib.ccpText + fib.ccpFtn + fib.ccpHdr + fib.ccpMcr + fib.ccpAtn and the limit CP of the entire plcfpcd is fib.ccpText + fib.ccpFtn + fib.ccpHdr + fib.ccpMcr + fib.ccpAtn + 1.