If you try to load CUNI_LS2.SYS with MS-DOS 6.0, you may receive the
following error message:
Corel LS2000 SCSI host adapter not found. Host adapter support code
When the computer has finished booting, the SCSI device is not
accessible. To work around this problem, you must specify the address
range that the device uses. Using the following syntax, add the /MEM
switch to the line in the CONFIG.SYS file that loads CUNI_LS2.SYS
where <xxx-xxxx> represents the entire address range at which the
device is located. The default for this range is D800-DBFF, however,
it can be changed using hardware switches.
If you try to load CUNIASP.SYS, no error message occurs, but the SCSI
device is still inaccessible.
To specify the address range while using CUNIASP.SYS, an additional
device driver must be loaded. The device driver ASPLS_D.SYS should be
loaded immediately before CUNIASP.SYS in the CONFIG.SYS file and
should have the following syntax
where <xxxx> represents the starting address used by the LS2000. The
default starting address is D800.
For more information on the above device drivers and the LS2000 SCSI
device, call Corel Technical Support.