ScanDisk Fails to Reset Video Mode Correctly (105061)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q105061
If you are running Video Dimensions (an MS-DOS-based screen control
program) when you run ScanDisk, your video mode may not be reset correctly.
For example, if the screen is set at 43 or 50 lines, when ScanDisk
exits, it places the screen in 67-line mode.
To work around this problem, do not load the Video Dimensions software
before you run ScanDisk.
| Modification Type:
|| Last Reviewed: