MSD 2.11 Does Not Print the Report You Selected (126819)

The information in this article applies to:

•

This article was previously published under Q126819

SYMPTOMS

When you are printing reports from Microsoft Diagnostics (MSD) version 2.11, the report that is printed is not the report you selected. For example, you select the AUTOEXEC.BAT report for printing, but the CONFIG.SYS report is printed instead. This also occurs when you print all the reports, but is not as noticeable because the reports are printed in sequence.

CAUSE

The memory browser report includes the AUTOEXEC.BAT report. This causes each subsequent report to move up one place in the report list.

RESOLUTION

To print reports from the AUTOEXEC.BAT report on, select the report before the report you want to print. The following table lists which report to select to print the report you want:

   Report wanted   Report to select
   --------------------------------
   AUTOEXEC.BAT    MEMORY BROWSER
   CONFIG.SYS      AUTOEXEC.BAT
   SYSTEM.INI      CONFIG.SYS
   WIN.INI         SYSTEM.INI
   MSMAIL.INI      WIN.INI
   PROTOCOL.INI    MSMAIL.INI

Modification Type:	Major	Last Reviewed:	11/22/1999
Keywords:	KB126819