Interrupt Setting for the IBM PS/2 Model 30 (28497)
The information in this article applies to:
• Microsoft InPort Mouse 1.x
• Microsoft Mouse driver for MS-DOS 6.x
• Microsoft Mouse driver for MS-DOS 7.x
• Microsoft Mouse driver for MS-DOS 8.x
This article was previously published under Q28497
SUMMARY
When you install the mouse InPort interface card on a PS/2 Model 30,
Microsoft recommends that you set the J4 interrupt to jumper 2 or 3.
Please check that other peripheral boards are not using the same
interrupt setting as the mouse. Do not use pair 5 for the setting.
The IBM product included here is manufactured by a vendor independent of
Microsoft; we make no warranty, implied or otherwise, regarding this
product's performance or reliability.
Modification Type: |
Major |
Last Reviewed: |
10/3/2003 |
Keywords: |
KB28497 |
|