"Interrupt Jumper Missing" Error Message (38754)
The information in this article applies to:
• Microsoft Mouse driver for MS-DOS 6.x
• Microsoft Mouse driver for MS-DOS 7.x
• Microsoft Mouse driver for MS-DOS 8.x
• Microsoft Bus Mouse 1.0
This article was previously published under Q38754
SUMMARY
When you install the Microsoft Mouse Driver and the Microsoft Bus Mouse,
you may receive the following error message:
Interrupt jumper missing
This error can be caused by any of the following;
• The interrupt selected on the J4 jumper is conflicting with existing
hardware. If the IRQ vector is being used by anything else, this
message appears.
• The J2 jumper on slot 8 is not set to normal (as it should be).
• The interface card is defective. This can only be verified by
installing the mouse and software on another machine and testing the
mouse.
| Modification Type: |
Major |
Last Reviewed: |
10/3/2003 |
| Keywords: |
KB38754 |
|