DESQview Version 2.33 or Earlier Conflicts with SETVER (74819)
The information in this article applies to:
• Microsoft MS-DOS operating system 5.0
• Microsoft MS-DOS operating system 5.0a
• Microsoft MS-DOS operating system 6.0
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.21
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q74819
SYMPTOMS
If you use DESQview version 2.33 or earlier, and you have SETVER.EXE loaded
as a device driver, the Setver device does not report the specified version
of MS-DOS to the application. This may result in the error message
"Incorrect DOS Version" when you run a program that requires a previous
version of MS-DOS, even though it is correctly loaded into the SETVER
table.
RESOLUTION
If you have programs that require the use of SETVER in MS-DOS and want to
run them in DESQview, contact the Quarterdeck Orders Department for an
upgrade of DESQview to version 2.34.
MORE INFORMATION
A list of programs that require SETVER is available by typing SETVER at
the MS-DOS command prompt. Additional programs may also require the use of
SETVER.
Contact the Quarterdeck for more information about DESQview.
The products included here are manufactured by vendors independent of
Microsoft; we make no warranty, implied or otherwise, regarding these
products' performance or reliability.
Modification Type: |
Major |
Last Reviewed: |
5/12/2003 |
Keywords: |
KB74819 |
|