Installing the PCLP Network with MS-DOS 5.0 and Later (75358)


The information in this article applies to:
    • Microsoft MS-DOS operating system 5.0
    • Microsoft MS-DOS operating system 5.0a
    • Microsoft MS-DOS operating system 6.0
    • Microsoft MS-DOS operating system 6.2
    • Microsoft MS-DOS operating system 6.21
    • Microsoft MS-DOS operating system 6.22
This article was previously published under Q75358

SUMMARY

This article describes procedures for upgrading IBM's PCLP network product to run with MS-DOS 5 or later.

If you have PCLP version 1.33, you must upgrade to version 1.34 to run with MS-DOS 5.0 or later. Detailed procedures are included in this article. If you have PCLP version 1.30, 1.31, or 1.32, you must upgrade to PCLP version 1.33 first. You cannot install version 1.34 over anything earlier than 1.33.

To obtain a PCLP upgrade or upgrades, contact the IBM Product Support Center.

MORE INFORMATION

To install PCLP 1.34 on a MS-DOS 5.0 or later machine, do the following:

    • Install MS-DOS 5.0 or later on the machine.
    • Follow the instructions in the README.TXT file on the PCLP 1.34 disks to upgrade your PCLP 1.33 disks.
    • Install PCLP 1.34 on the machine.
If you have PCLP version 1.30, 1.31, or 1.32, you must upgrade to PCLP version 1.33 first. After installing the upgrade to PCLP version 1.33, follow the above steps. The PCLP product included here is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Modification Type: Major Last Reviewed: 5/12/2003
Keywords: KB75358
©2002 Microsoft Corporation. All rights reserved.