Using Bernoulli Driver Version 7.0 or Later with MS-DOS (75689)
The information in this article applies to:
• Microsoft MS-DOS operating system 5.0
• Microsoft MS-DOS operating system 5.0a
• Microsoft MS-DOS operating system 6.0
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.21
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q75689
SUMMARY
For compatibility with MS-DOS version 5.0 or later, you need version 4.7 or
later of the Bernoulli driver. If your Bernoulli driver is earlier than
4.7, it may lock the machine during startup.
MS-DOS 5.0 or later cannot load the Bernoulli driver high unless version
7.0 or later is used.
MORE INFORMATION
Version 7.0 of the Bernoulli driver is the latest driver available from
IOMEGA. This driver requires a model PC2, PC2B, or PC4B Bernoulli adapter
card. If you have an earlier model of the adapter card, you can upgrade by
contacting IOMEGA.
If you have the correct adapter card and boot your machine from the
Bernoulli drive, you will need to obtain a kit from IOMEGA that includes
version 7.0 of the driver, a manual, and an EPROM chip. If you have the
correct adapter card but do not boot from the Bernoulli drive, you will
only need to obtain version 7.0 of the driver and the manual from IOMEGA.
The new 7.0 driver is available from IOMEGA customer support or by calling
their bulletin board and downloading 700.ZIP and 700.EXE.
Version 5.2 of the Bernoulli driver for the PC3B adapter is available
from IOMEGA customer support. Version 5.2 is compatible with MS-DOS
5.0 and later as long as it is not loaded high.
For more information on any of the above products, call IOMEGA at one
of the numbers below.
The product included here is manufactured by vendors independent of
Microsoft; we make no warranty, implied or otherwise, regarding this
product's performance or reliability.
Modification Type: |
Major |
Last Reviewed: |
5/12/2003 |
Keywords: |
KB75689 |
|