Shadow RAM Technical Information (78536)
The information in this article applies to:
• Microsoft MS-DOS operating system 5.0
This article was previously published under Q78536
This article explains what shadow RAM is and how you can use it.
What Is Shadow RAM?
Shadow RAM is best explained by means of an example. Most Compaq
machines have a shadow RAM region for their video ROM. The original
video ROM resides in the C000 segment, and typically extends from C000
In general, the execution time in RAM is less than that in ROM. So, to
speed up the video performance, the video ROM is copied into fast
32-bit RAM. The system ROM BIOS maps this in from E000 to E6FF at boot
When Would You Need to Reclaim Shadow RAM?
Because of the shadowing of the video ROM, the same ROM appears in two
places, one in the C000 segment and the other in the E000 segment,
although only one of them is used. Because of this, simulators like
EMM386 will lose some upper memory block (UMB) space.
Can Shadow RAM Be Used for Loading Devices?
Some people may be able to use some of their shadow RAM for loading
devices high. This is possible on some computers.
As mentioned in the section above, the E000 segment is available for
loading as a UMB, so programs can be loaded high into shadow RAM.
It is also possible that your system ROM is itself shadowed.
Typically, a shadow of the F000 segment is available in the E000
segment (or vice versa). In this case, it may be possible to use one
or the other as a UMB by specifying the include option in EMM386, but
this requires correct information about the hardware configuration.
Using the HIMEM.SYS /shadowram:off Switch
You can use the /shadowram:off switch on the DEVICE command for
HIMEM.SYS. This switch instructs HIMEM.SYS to disable RAM shadowing;
the shadow RAM then no longer appears in the E000 segment.
Currently, the /shadowram:off switch works only on COMPAQ systems.
The shadow RAM can be added to the XMS pool with HIMEM.SYS when the
/shadowram:off switch is specified.
How Do You Address Shadow RAM?
For real and virtual 86 modes, you can think of shadow RAM as physical
memory addressed exclusively in the 640-1024K range.
However, for protected mode, it is possible to access the actual
physical address of the shadow RAM region by specifying its 32-bit
address (if you know where it is physically located).
The products included here are manufactured by vendors independent of
Microsoft; we make no warranty, implied or otherwise, regarding these
products' performance or reliability.
| Modification Type:
|| Last Reviewed: