Default Device Drivers in SETVER Table (78719)
The information in this article applies to:
• Microsoft MS-DOS operating system 5.0
• Microsoft MS-DOS operating system 5.0a
This article was previously published under Q78719
The SETVER.EXE device driver included with Microsoft MS-DOS 5 Upgrade
contains a table of default entries. This article contains a list of
the default entries for SETVER.EXE.
If SETVER.EXE is used to reference a device driver, SETVER must be
entered before the specified device driver in the CONFIG.SYS file.
If a device driver is loaded in the CONFIG.SYS file and is referenced
in the SETVER table, that device driver must be loaded after
SETVER.EXE in CONFIG.SYS.
The following is an example of loading the device driver SSTDRIVE.SYS
in CONFIG.SYS after SETVER.EXE:
The default SETVER table as supplied in MS-DOS 5.0 contains the
The products included here are manufactured by vendors independent of
Microsoft; we make no warranty, implied or otherwise, regarding these
products' performance or reliability.
| Modification Type:
|| Last Reviewed: