MemMaker Err Msg with QEMM: 'Bad Command or Filename' (94358)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.0
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.21
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q94358
SYMPTOMS
If you are using QEMM to load your files into upper memory and the FILES
command has a plus (+) sign for a delimiter (for example, C:\QEMM\LOADHI
/R:1 FILES+30), you will receive the following error message:
Bad Command or Filename
CAUSE
Using a plus sign as a delimiter is not standard for MS-DOS. If your
QEMM command contains "FILES+nn", MemMaker returns the error message
noted above.
WORKAROUND
To work around the problem, remove the QEMM "FILES+nn" command from
your AUTOEXEC.BAT file and use the "files=" setting in your CONFIG.SYS
file to specify the number of open files. Run MemMaker again to ensure
that you have the optimal memory configuration.
| Modification Type: |
Major |
Last Reviewed: |
11/23/1999 |
| Keywords: |
KB94358 |
|