Insufficient Memory Error Message with DBLSPACE /RATIO (94386)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.0
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.22
• Microsoft Windows for Workgroups 3.1
• Microsoft Windows for Workgroups 3.11
This article was previously published under Q94386
SYMPTOMS
If you run DBLSPACE /RATIO before the NET command is used in the
AUTOEXEC.BAT file, you may receive an insufficient memory error
message.
CAUSE
This problem occurs when the network has not released the memory used
during loading because network binding has not yet occurred.
RESOLUTION
It is not necessary to run DBLSPACE /RATIO from the AUTOEXEC.BAT file
since DoubleSpace reliably reports the amount of free disk space.
However, if you want to run DBLSPACE /RATIO from the AUTOEXEC.BAT
file, place the NET START command before the DBLSPACE /RATIO command,
as in the following example:
c:\windows\net start
c:\dos\dblspace /ratio
| Modification Type: |
Major |
Last Reviewed: |
11/23/1999 |
| Keywords: |
KB94386 |
|