DBLSPACE.SYS /MOVE or DRVSPACE.SYS /MOVE in CONFIG.SYS Twice (95816)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.0
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q95816
NOTE: Although the text in this article specifically refers to MS-DOS 6.2
DoubleSpace, the information also applies to MS-DOS 6.22 DriveSpace. If you
have MS-DOS 6.22, substitute DRVSPACE for any DBLSPACE commands.
SUMMARY
During installation, DoubleSpace may add the statement
DEVICEHIGH=C:\DOS\DBLSPACE.SYS /MOVE to the CONFIG.SYS file more than once.
DoubleSpace adds this line to more than one location in the CONFIG.SYS file
if DoubleSpace determines that DBLSPACE.BIN may cause problems for network
device drivers.
MORE INFORMATION
DBLSPACE.SYS /MOVE does not load a device driver for DoubleSpace. Instead,
it moves the DoubleSpace component (DBLSPACE.BIN) into memory. Multiple
instances of DBLSPACE.SYS do not use additional memory because this device
driver simply moves DBLSPACE.BIN and then unloads itself.
| Modification Type: |
Major |
Last Reviewed: |
11/19/1999 |
| Keywords: |
KB95816 |
|