NCR Laptop Driver FD82365.SYS Causes "Invalid Disk..." Error (97612)



The information in this article applies to:
    Microsoft MS-DOS operating system 6.0
    Microsoft MS-DOS operating system 6.2
    Microsoft MS-DOS operating system 6.21
    Microsoft MS-DOS operating system 6.22

This article was previously published under Q97612

SYMPTOMS

Your NCR or AT&T 3170 386 laptop displays the following error message:

INVALID DISK CHANGE READING DRIVE A:

CAUSE

FD82365.SYS is a driver for PCMCIA cards; if this driver is loaded, or the PCMCIAPower=ON in the system CMOS settings, the above error occurs after you install MS-DOS 6.0 or later.

WORKAROUND

Remove the FD82365.SYS driver from the CONFIG.SYS file and change the system CMOS setting to the following:
   PCMCIAPower=OFF
NCR has an updated driver available that corrects this problem. For more information, contact NCR Technical Support.

The products included here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

Modification Type: Major Last Reviewed: 12/30/1999
Keywords: KB97612